Gima Sonoline C Manual Del Usuario página 31

ENGLISH
31
4.3.2 Replacing Probe
There has been a probe connected to device while packaged by the
manufacturer. If users need to replace it with another probe, power off the device
at first, then take out the probe from the parking of device. And then pull out
the plug of the probe from its socket. Then connect the plug of the probe which
needs to be displaced with the socket.
Note: Place the temporarily unused probe carefully and avoid falling off,
stress, etc. When the device is not used for a long time, users are
recommended to connect the plug of one probe to device socket and
put the probe in the parking. Then pack the device with the probe
in the wrapping box.
4.3.3 Taking out Probe and Placing Probe
1. Taking Out The Probe
Hold the main unit with one hand, and hold the handle of the probe with another
hand to take out the probe. (See Fig.4-1).
Fig. 4-1 Taking out Probe
2. Placing Probe
It is opposite to take out probe. Hold the main unit with one hand, and hold the
top of the probe with another hand, then push the probe into the probe holden.