dirna Bergstrom bycool DINAMIC 1.2 Instrucciones De Montaje página 26

DINAMIC 1.2
EN ES
CONDENSER ASSEMBLY:
Important: Depending on the vehicle, we can position
the pipe outputs on the right or left side.
1
Note: When the installation is carried out by just
one person, mark the bores with the indicated
measurements, taking into account the pipe
length (from the evaporator to the condenser).
2
Dismount the cover and release the electro-
cabling.
3 If this is carried out by 2 people, introduce the
capacitor base, placing it at the most appropriate
part of the rear of the cabin, taking into account
the pipe length from the evaporator to the
condenser, and secure with at least 6 bores.
3A First make the (2) upper bores (X) at Ø 9, position
M6 rivet nuts and position the base with screws
6/100x30, mark and make the rest of the bores
(Y), position the nuts.
3A
X
Y
Left pipe output
26
Air conditioning for vehicles
ALWAYS
Right pipe output
491
3