Sharpening The Line Cutting Blade; Correcting Grass Bind - Oregon ST275-GSL Manual De Instrucciones

SHARPENING THE LINE CUTTING
BLADE
It is recommended that an Oregon® Service
Dealer sharpen the line cutting blade, but it
can also be sharpened by the operator
Line cutting blade sharpening requires a flat
file
After collecting the file, wear gloves and eye
protection and remove the battery
• Lay the trimmer on its side with the line
cutting blade on top and face the bottom of
the trimmer head (Fig 27)
• Place the file against the cutting edge of the
line cutting blade (1)
• Push the file down and to the right, removing
material from the cutting edge (2)
FIG 27
• Repeat until the line cutting blade is sharp
28
ST275_Operating_Manual_EU.indd 28
SAFETY RULES
(2)
(1)

CORRECTING GRASS BIND

CAUTION: A BATTERY OPERATED
TOOL WITH THE BATTERY PACK
INSERTED IS ALWAYS ON AND CAN
START ACCIDENTALLY. ALWAYS
REMOVE THE BATTERY BEFORE
CORRECTING GRASS BIND TO AVOID
ACCIDENTAL ACTIVATION OF THE
TRIMMER HEAD.
Certain types and lengths of grass can
sometimes be caught between the trimmer
head and the spindle When this happens,
the grass quickly winds around the shaft
clogging the space between the shaft and the
trimmer head and slowing or stopping the
trimmer head rotation This condition is called
grass bind The trimmer/edger is equipped
with a grass wrap protector shroud between
the trimmer head and the spindle to help
minimise grass bind, but the condition can
still occasionally occur
To correct grass bind:
• Remove the battery
• Remove the trimmer head
• Clean all grass or weeds from the spindle If
necessary, cut the grass or weeds free
• Once the spindle is cleared, replace the
trimmer head
Oregon® Trimmer/Edger Model ST275-GSL
17/06/16 9:44 AM