Replacing The Gator® Speedload™ (Gsl) - Oregon ST275-GSL Manual De Instrucciones

REPLACING THE GATOR®
SPEEDLOAD™ (GSL)
The trimmer/edger is equipped with the
innovative GSL Cutting System The GSL head
contains a disk of trimmer line that is pre-
wound and self-contained The GSL disk lasts
longer than typical trimmer line Removing
and replacing a disk is simple
• Pull the head off the base Pull out the spent
disk and discard it (Fig 19)
FIG 19
• Peel two separate pieces of trimmer line
from opposite sides of the disk Make sure
each piece is pulled away to create a small
gap between the peeled trimmer lines and
the disk (Fig 20)
FIG 20
26
ST275_Operating_Manual_EU.indd 26
SAFETY RULES
• Place the disk inside the head by lining the
disk's centre hole with the hole in the centre
of the head Press the disk firmly into place
(Fig 21)
FIG 21
• Make sure the ends of the trimmer line
pieces fit through the two sets of pegs in the
head (Fig 22)
FIG 22
• Place GSL head back onto the base and
press firmly until it clicks into place
The innovative tongue-and-groove disk
eliminates the need for threading of trimmer
line Disks last longer than traditional
trimming lines
Oregon® Trimmer/Edger Model ST275-GSL
17/06/16 9:44 AM