Temperature Setting; Dry Ironing - Beper 50.943 Manual De Instrucciones

Plancha seca
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Dry Iron Use instructions

TEMPERATURE SETTING

Always check the washing and ironing labels of clothes. If necessary, see instructions below:
The number of points on the thermostat indicate the temperature from the lower one (•) to the higher
one (•••).The table is valid for fabrics and not for brilliant surfaces, with relief printings or folds which
must be ironed with low temperature.
Before using the iron, always make sure that the temperature of iron is adapted to the type of fabric:
wool with wool, cotton with cotton, etc.
The iron heats quickly and cools slowly; thus always start with clothing which requires a low tempe-
rature (like synthetic fabrics) and always progress with the highest temperatures..
When the cloth is made of several fabrics, set the temperature for the most delicate fabric.
If you do not know the type of fabric we recommend to iron the internal parts of clothing, from lowest
temperature, and then finding the temperature more adapted. If clothing becomes "brilliant", stop
immediately in order to not damage it. Then start to iron it on the back.
N.B. Pay attention to the symbol

DRY IRONING

Set the steam indicator on
by using the thermostat.
The light indicator illuminates and switch off when the soleplate is at good temperature.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
CLEANING
Unplug the appliance from the socket.
To remove dirt on the soleplate, use a wet cloth or with a little quantity of non abrasive detergent
when the soleplate is still hot.
For hard dirt, use special detergent.
Always dry the soleplate after cleaning.
Clean the whole iron with a wet cloth without detergent.
Do not use metallic sponge or abrasive detergent.
SYMBOL
FABRIC
Do not iron
Synthetic, Nylon, Acryilic, Rayon
Wool, Silk
Cotton, Flax
in order to not to use steam function. Set the soleplate temperature
: that means that the fabric must not be ironed.
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

50.931

Tabla de contenido