The Funtion Of Keys; Installation; Turning On The Power; Span Calibration - Baxtran ABS6 Manual De Usuario

User's Guide
Installs the balance in a firm weighing site and avoid vibration, air flow from air-conditioner, open
window, or ventilator, and electromagnetic waves.
Note: Before installation and use: please make sure to loosen the red screw which is use to protect the
transducer. And please keep the red screw properly in order to use it when the balance need to transport.
Insert the plug of the AC adapter into the DC IN connector on the rear of the balance or dry batteries
of 12v into the battery compartment.
Turn on the
wait for seconds(depending on the working environment) to display "0--0.0--0.00--0.000" weighing
mode.
4.1 NOTA
Please allow the balance to warm up for 10~30 minutes (depending on the different type of balances)
when first time turn on
4.2. CALIBRATION
a. Verify that the pan is empty, press and hold
release the
b. Load the indicated weight which's number is blinking on the LCD, wait the number stop blinking, Un-
10
Turn on/off the balance.
Change the weighing unit.
Tare the balance.
Switch between different modes.
Enter span calibration.
key, and it will display "XXXX" which stands for the maximum weighing value, and
in order to make the balance adapt the environment.
key.
1. THE FUNCTION OF KEYS

3. TURNING ON THE POWER

4. SPAN CALIBRATION

key about 5 seconds, when the display shows "CAL",
ABS

2. INSTALLATION