Product Description And Specifications; Intended Use; Product Features - Bosch GTS 10 XC Professional Manual Original

36 | English
Symbols and their meaning
Direction of rotation of the knurled screw
to fix/release the angle guide on the slid-
ing table.
Oil the power tool as necessary at the
points indicated.
Protection class II power tools are
strengthened or double-insulated.
The CE mark provides confirmation from
the manufacturer that the power tool
complies with the applicable EU Direct-
ives.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.

Intended use

The power tool is a stationary machine for cutting in a
straight line with and against the grain in hardwood, soft-
wood, chipboard and fibreboard. Mitre angles of –60° to
+60° as well as bevel angles of -1° to 47° are possible.
It is also possible to saw aluminium profiles and plastic using
the appropriate saw blades.

Product features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) Scale for spacing between saw blade and parallel
guide
(2) Slide carriage
(3) Angle guide
(4) Carrying handle
(5) Label for marking the cutting line
(6) Protective cover
(7) Riving knife
(8) Parallel guide
(9) Guide groove for angle guide
Saw table extension
(10)
(11) Saw table expansion
(12) Securing nut for the saw blade storage compart-
ment cover and for hanging the push stick
1 609 92A 7WN | (14.06.2022)
(13) Push stick
(14) Saw blade storage compartment cover
(15) Ring spanner (24 mm; 23 mm)
(16) Mounting holes
(17) Saw table
(18) Clamping handle for saw table expansion
(19) Hand wheel
(20) Crank for raising and lowering the saw blade
(21) Safety flap for the on/off switch
(22) Bracket for storing the protective cover
(23) Holding clip for storing the angle guide
(24) Guide bar of the saw table extension
(25) Stop for 45° bevel angle
(26) Locking lever for setting the bevel angle
(27) Scale for bevel angles
(28) Stop for 0° bevel angle
(29) Clamping handle for slide carriage
(30) V guide groove on the saw table for the parallel
guide
(31) Adjusting screw for adjusting the clamping force of
the parallel guide
(32) Table insert
(33) Saw blade
(34) Profile rail
(35) Guide groove for parallel guide
(36) Parallel guide storage compartment
(37) Hex key (5 mm)
(38) Locking screw of the saw table extension
(39) "Additional parallel guide" fastening set
Chip ejector
(40)
(41) Dust extraction adapter
(42) Cable holder
(43) "Saw table extension" fastening set
(44) V guide for parallel guide
(45) Base plate
(46) Clamping lever for riving knife
(47) Positioning pins for riving knife
(48) Recesses for table insert
(49) Clamping lever for protective cover
(50) Guide pin for protective cover
(51) Clamping handle for parallel guide
(52) Additional parallel guide
(53) Guide rail for angle guide
(54) Knurled screw for fixing the angle guide
(55) "Profile rail" fastening set
(56) Knurled nut for profile rail
(57) Lower saw blade cover
Bosch Power Tools