Panasonic EY3610 Manual De Instrucciones página 8

For hard compounds
• Warm the sealing compounds until the
compounds become soft.
• Increase the speed by selecting the
application speed control.
• Make the nozzle cut diameter bigger.
(Fig. 15)
CAUTION:
• Make sure the front cap is tightened
securely when working.
• Use the tool only for its intended purpose,
and do not operate it for long periods of
time without interruption, since this may
damage the sealing gun or cause the
cartridge to jam. Do not insert a cartridge
if it is wet, or if the sealing compound has
hardened.
• If the tool is operated for long periods of
time, the motor may overheat.
It is therefore recommended to switch it
off from time to time.
• The use of fl ammable materials, even for
cleaning purposes, is not permitted.
• Do not squeeze the trigger with an empty
sealing compound. (It causes a failure.)
How to adjust the remaining
amount indicator
If you touch the stopper, the rack will
shift back. In that case the remaining
amount indicator will not change to white
completely even if you push the rack all
the way in. To reset the indicator, try the
following procedures.
1) Fully extend the rack.
Stopper
• After extending the rack to the end by
squeezing the trigger, pull it out further
by hand until it clicks.
EY3610_EU.indb 8 EY3610_EU.indb 8
2) Keep squeezing the trigger until the
lower half of the remaining amount
indicator becomes red and the upper
half becomes white.
White
Red
3) Release the trigger, then push the rack
all the way in by hand. (Fig. 8)
[Battery Pack]
For Appropriate Use of
Battery pack
Li-ion Battery pack
• For optimum battery life, store the Li-
ion battery pack following use without
charging it.
• When charging the battery pack, confi rm
that the terminals on the battery charger
are free of foreign substances such as
dust and water etc. Clean the terminals
before charging the battery pack if any
foreign substances are found on the
terminals.
The life of the battery pack terminals may
be affected by foreign substances such
as dust and water etc. during operation.
• When battery pack is not in use, keep it
away from other metal objects like: paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a
connection from one terminal to another.
Shorting the battery terminals together
may cause sparks, burns or a fi re.
• When operating the battery pack, make
sure the work place is well-ventilated.
Battery Pack Life
The rechargeable batteries have a
limited life. If the operation time becomes
extremely short after recharging, replace
the battery pack with a new one.
Battery Recycling
ATTENTION:
For environmental protection and recycling
of materials, be sure that it is disposed of
at an offi cially assigned location, if there is
one in your country.
8
2012/07/20 14:22:56 2012/07/20 14:22:56