Warnings And Precautions; Battery Installation - Bresser NightSpy Serie Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39

WARNINGS AND PRECAUTIONS

Your NightSpy night vision was designed to provide many years of relia-
ble service. To ensure that you get the most enjoyment out of your NV
Shadow always obey the following Warnings and Precautions:
• Do not point the NightSpy towards any light source greater than 1 lux
(such as car headlights) for an extended period of time. The NightSpy
utilizes an internal flash protection system, which minimizes potential
damage, but long-term exposure to bright lights can damage the unit.
Any such damage may void your warranty.
• Your NightSpy was designed to be self-contained. Do not open the
body of the device or otherwise attempt to service this device.
• Always store the NightSpy in a dry, well-ventilated room.
• Keep the NightSpy away from any heating and air con ditioning vents or
other heating devices, direct sunlight, and moisture.
• Avoid dropping or otherwise shocking the unit. Although designed for
rugged outdoor use, the NightSpy incorporates a sophisticated optical
system which could be damaged in extreme cases of misuse.
• Clean optical parts (lenses) with professional lens cleaning supplies
15
designed for use with multicoated optics.
• Clean the exterior of your NightSpy with a soft, clean cloth.
• Damage to this device from failure to observe these warnings may void
the NightSpy's warranty!

BATTERY INSTALLATION

To install, unscrew the battery compartment cover (6), insert the battery
(CR123A) into the battery compartment so that the positive (+) and neg-
ative (-) terminals of the battery match the markings inside the compart-
ment, replace the battery cover carefully. Do not over tighten.
USING THE NIGHTSPY
After installing the battery the NightSpy is ready for use. Please keep the
following points in mind:
• Move into a dark area before activating the NightSpy light amplifier.
• Remove the protective cover(s) (5) from the lens / lenses (3).
• Activate the device by pushing the „ON" button (1).
• If the subject to be viewed is in a complete dark area, including lowlight
DE
GB
FR
NL
IT
ES

Publicidad

Tabla de contenido
loading

Tabla de contenido