MRA KAWASAKI Versys 650/1000 2017- Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
4 M5 X 16 MM OVAL-HEAD SCREW BLACK
4 12 X 5 X 0.5 MM WASHER PLASTIC
4 3 MM SPACER SLEEVE
4 5.3 MM WASHER BLACK
Removing the original windscreen:
1. Place the motorcycle on a flat surface.
2. Pull out the knurled nuts cover caps (P 1).
3. Now remove the screws and washers with the 4 mm Allen key (P 1).
4. Loosen and remove the knurled nuts and washers by turning them to the left (P 1).
5. Now remove the windscreen from the holder.
INFO: Make sure that you do not lose the two plastic washers.
6. Now remove the holding plate from the original windscreen.
Mounting the MRA windscreen:
7. Insert the provided M5x16mm oval-head screws with the plastic washers into the holes on
the MRA screen.
8. Now insert the 3 mm spacer sleeves into the holding plate from behind, as shown in pictures
2,3 and 4, and push the 5 mm steel washers onto the oval-head screw and then fit the
original M5 cap nuts. Now tighten the screws.
9. Mount the MRA windscreen to your motorbike again and tighten all four screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Versys 650/1000 17-
Article No..
--- Allen key 3mm and 4mm
10554 Flat-tip screwdriver Gr. 2
Spanner 8 mm
10635
10872
10999
3
Required tools