Troubleshooting - Skil 5280 Manual Del Propietário

TROUBLESHOOTING

WARNING
Trouble Problem
Saw will not 1. Power cord is not plugged in.
start
2. Power source fuse or circuit
3. Cord damaged.
4. Burned out switch.
5. Trigger does not turn tool on.
Blade does 1. Extension cord too light or too
not come up to
speed
2. Low house voltage.
Excessive 1. Blade out of balance.
vibration
2. Workpiece not clamped or
Cannot 1. Foot not adjusted properly.
make square
cut when
crosscutting
Cut binds, 1. Dull blade with improper tooth
burns, stalls,
motor when
2. Warped board.
ripping
3. Blade binds.
4. Improper workpiece support.
Blade slipping 1. Tool does not cut workpiece.
24
Read instruction manual first! Remove plug from the power source before
making adjustments or assembling the blade.
breaker tripped.
long.Extension cord too light
or too long.
supported properly.
set.
Remedy
1. Plug saw in.
2. Replace fuse or reset tripped circuit
breaker.
3. Inspect cord for damage. If damaged,
have cord replaced by an Authorized
Skil Service Center or Service Station.
4. Have switch replaced by an Authorized
Skil Service Center or Service Station.
5. Disengage Safety Switch as described
on page 18.
1. Replace with adequate cord.
2. Contact your electric company.
1. Discard Blade and use different blade.
2. Clamp or support workpiece as shown
on pages 17 and 20.
1. See "Operating Instructions" section,
"Bevel Adjustment" (page 17), "Line
Guide" (page 17), "Cutting Large
Sheets (page 20) and "Rip Cuts"
(page 21).
1. Discard blade and use a different
blade.
2. Make sure concave or hollow side is
facing "DOWN" feed slowly, see
(page 20).
3. Assemble blade and tighten
Vari-Torque clutch per "Assembly",
see (page 14 and 15).
4. Clamp or support workpiece as shown
on pages 17 and 20.
1. Assemble blade and tighten
Vari-Torque clutch per "Assembly",
see (page 14 and 15).