Troubleshooting - Skil CR5429B-00 Manual Del Propietário

TROUBLESHOOTING

Problem
Tool does not start.
Blade does not come up
to speed.
Excessive vibration.
The blade does not follow
a straight line.
Cut binds, burns, stalls
motor when ripping.
Blade slipping.
Cause
1. Battery packs are depleted.
2. One or both battery packs are
not installed properly.
3. Burned out switch.
1. Low battery charge.
1. Blade out of balance.
2. Workpiece not clamped or
supported properly.
1. Blade teeth are dull.
2. Foot is out of line or bent.
3. Blade is bent.
1. Dull blade with improper tooth
set.
2. Blade binds.
3. Improper workpiece support.
1. Tool does not cut workpiece.
Remedy
1. Charge the battery packs.
2. Confirm that the battery
packs are properly
attached to the tool.
3. Have the switch replaced
by an Authorized SKIL
Service Center or Service
Station.
1. Recharge the battery
packs or use fully charged
packs.
1. Discard blade and use a
different blade.
2. Clamp or support
workpiece properly
according to this manual.
1. Change to a new blade.
2. Have the tool repaired by
an Authorized SKIL Service
Center or Service Station.
3. Change to a new blade.
1. Discard blade and use a
different blade.
2. Reassemble the blade
and tighten the washers
according to this manual.
3. Clamp or support
workpiece properly
according to this manual.
1. Reassemble the blade
and tighten the washers
according to this manual.
23