Dexter 350OS2.5 Manual De Instrucciones página 127

Lijadora excéntrica
Tabla de contenido

Publicidad

4.
To remove the sanding paper, peel it away from the base.
1.
Select the required grade of sanding paper.
5.
Ordinary (non Hook & Loop type) sanding paper can also be used.
RO
2.
Remove any dust or debris from the hook and loop of the base.
6.
Release the sandpaper clamp from both sides of the sander.
3.
To attach hook & loop type sanding paper simply align the holes in the sanding paper
7.
Insert the end of the sandpaper under one clamp and pull the paper tight over the base
EN
ensuring the holes align with those in the base and then clamp the other side.
4.
To remove the sanding paper, peel it away from the base.
8.
The sanding paper should be kept tightly clamped over the base, otherwise there could
5.
Ordinary (non Hook & Loop type) sanding paper can also be used.
be excessive wear of the base material.
6.
Release the sandpaper clamp from both sides of the sander.
7.
Insert the end of the sandpaper under one clamp and pull the paper tight over the base
WARNING: Do not continue to use the sander with a sanding paper
ensuring the holes align with those in the base and then clamp the other side.
that is overworn or damaged.
8.
The sanding paper should be kept tightly clamped over the base, otherwise there could
WARNING: Do not use the same sanding paper for wood and metal.
be excessive wear of the base material.
Metal particles become embedded in the sanding paper and will
scour a wooden surface.
WARNING: Do not continue to use the sander with a sanding paper
WARNING: Take care to regularly clean out the build up of dust on the
that is overworn or damaged.
base underneath the sanding paper and not to let the sanding paper
WARNING: Do not use the same sanding paper for wood and metal.
wear completely down before replacing it. Failure to observe these two
Metal particles become embedded in the sanding paper and will
precautionary measures can lead to damage to the hooks and loops on the
scour a wooden surface.
base and the sanding paper will not attach properly.
WARNING: Take care to regularly clean out the build up of dust on the
160
base underneath the sanding paper and not to let the sanding paper
wear completely down before replacing it. Failure to observe these two
precautionary measures can lead to damage to the hooks and loops on the
base and the sanding paper will not attach properly.
160
FR
FR
FR
ES
ES
ES
PT
PT
PT
IT
IT
IT
EL
EL
EL
PL
PL
PL
RU
RU
RU
KZ
KZ
KZ
UA
UA
UA
RO
RO
RO
EN
EN
EN
111
111
127

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

300ds2.5

Tabla de contenido