Dexter 350OS2.5 Manual De Instrucciones página 177

Lijadora excéntrica
Tabla de contenido

Publicidad

8. TROUBLE SHOOTING
Problem
Possible cause
Not connected to power supply
Product does
Power cord or plug is defective
not start
Other electrical defect to the product
Extension cord not suitable for
operation with this product
Product does
Power source (e.g. generator) has
not reach full
too low voltage
power
Air vents are blocked
Sanding sheet is worn
Unsatisfactory
result
Sanding sheet not suitable for work
piece material
9. PROTECT OUR ENVIRONMENT
Electrical products must not be thrown out with domestic waste. Recycle them at
the special disposal centers provided for the purpose. Contact your local authorities
or stockiest for advice on recycling.
The potential e ects on the environment and human health as a result of the
presence of hazardous substances in electrical and electronic equipment.
For disposal, this tool also can be returned to the hardware store or vendor (or
Dexter Power dealer).
Solution
Connect to power
supply
Check by a specialist
electrician.
Check by a specialist
electrician
Use a proper
extension cord
Connect to another
power source
Clean the air vents
Replace with a new
one
Use suitable sanding
paper
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
177

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

300ds2.5

Tabla de contenido