Ferm FDAG-750 Manual De Instrucciones página 6

GB
• Fasten the side handle for left-hand operation
on the right-hand side of the machine.
• Fasten the side handle for right-hand operation
on the left-hand side of the machine.
Make sure that the side handle is
fastened properly and cannot loosen
unexpectedly.
Mounting the guard
Fig. 2
Mount the guard before using the machine.
Assembly
• Place the guard (2) on the housing. Be aware
that the notch of the guard falls across the edge
of the housing.
• Place the fixing-ring (7+12) on the guard: the
ring-holes have to be on the screw-holes.
• Mount the guard en fixing-ring with help of the
4 screws and washers (8).
• The closed side of the guard always has to
point in the user's direction.
Be aware the screws are tightened well
enough. Check regularly if the screws
are still fixed.
Disassembly
• Remove the flange nut and the grinding disc
with lower flange from the spindle.
• Unscrew the 4 screws (with washers) en
remove the fixing-ring.
• Remove the guard from the machine.
•
Mounting a grinding disc
Fig. 3
Use grinding discs of the correct dimension. Use
fibre reinforced grinding discs only. The grinding
disc must not touch the edge of the guard.
Remove the plug from the mains
• Press the spindle lock (Fig. 1 - 5) and turn the
spindle (6) until it engages in the lock. Keep the
spindle lock pressed during this procedure.
• Remove the flange nut (10) from the spindle
using the spanner (11).
• Position the grinding disc on the flange (9).
• Place the flange nut on the spindle and tighten
it using the spanner.
6
• Release the spindle lock and check that the
spindle is unlocked by rotating it.
Mounting grinding discs and roughing discs
Fig. 4 and 5 show how to mount the flange (10)
when using thick (4 – 8 mm) and thin (2,5 – 4 mm)
discs.
4. USE
Always observe the safety instructions
and applicable regulations.
Special attention when starting the machine
• Clamp the workpiece and make sure that the
workpiece cannot slide from under the machine
during the cutting activities.
• When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
• Always direct the cable to the rear away from
the machine.
• Insert the mains plug only when the machine is
switched off.
• Apply the machine to the workpiece only when
switched on
Never use the machine for grinding
magnesium workpieces.
Switching on and off
• Slide the on/off switch forwards.
• To switch off, depress the on/off switch, this will
then jump to the 'off' position.
Do not put the machine down when the
motor is still running. Do not place the
machine on a dusty surface. Dust
particles may enter the mechanism.
Operation
• Hold the machine firmly and move it against the
workpiece. Move the grinding disc evenly
across the workpiece.
• Move the machine during roughing under an
angle of 30º - 40º across the workpiece (Fig. 6).
Never use grinding discs for roughing!
Ferm