Problems And Solutions - Sunrise Medical SUNLIFT Micro Manual De Instrucciones

9. User guide for the quickfit sling
From a sitting position
Fig. 1
Ensure that the straps face outward. Pull the sling down over the user's back until the top of the toilet seat opening is at the small of
the back. Check that the sling is aligned properly at shoulder height.
Fig. 2
Lift the patient's leg and slip the strap under it and pull it up between their legs, ensuring that the sling is not creased under the thigh.
Repeat the procedure with the other leg.
Fig. 3
Cross the straps over the legs and attach them to the front hooks on the hoist spreader bar.
Fig. 4
Raise the hoist slightly and attach the shorter, shoulder straps to the spreader bar. Move the hoist towards the patient while doing
this.
Fig. 1
REMEMBER: THE LONG STRAPS ARE FOR THE LEGS, AND THE SHORT ONES FOR THE
SHOULDERS.
From a lying position
Fig. 5
Roll the patient over onto the sling, ensuring that the top of the toilet seat opening is at the small of the back.
Fig. 6
Cross the straps under the patient's legs and fit the sling as indicated for the sitting position, keeping the shoulder straps as short
as possible.
Fig. 5
NB: ENSURE THAT THE PATIENT'S HEAD IS SUPPORTED AT ALL TIMES

10. Problems and solutions

PROBLEM
Actuator does not work
Batteries do not charge
The actuator stops
14
Fig. 2
Fig. 6
CAUSE
Emergency button pressed
Total battery discharge protection activated
Poor connection of the control plug
Fully charged battery (green light)
Overload in the hoist
Batteries discharged (yellow flashing light and sound
warning when pressing the hand control: protection
against total discharge activated)
Fig. 3
SOLUTION
Turn it in the sense of the arrows
Charge the batteries
Reinsert the control plug
Verify power source
Reduce the load on the actuator
Charge batteries
Fig. 4