Makita CL111D Manual De Instrucciones página 5

Switch action
CAUTION:
Before using the tool, always
check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
► 1 . Switch trigger
Battery power lamp
When the remaining battery capacity gets low, the
battery power lamp blinks.
When the remaining battery capacity gets much lower,
the tool stops and the battery power lamp lights up
about 10 seconds. At this time, charge the battery.
Also when the battery gets overloaded or overheated,
the tool stops and the battery power lamp lights up
about 10 seconds. The tool does not actuate during the
lamp on.
1
► 1 . Battery power lamp
NOTE: The time at which the battery power lamp start
blinking or lighting up depends on the temperature at
work place and the battery conditions.
ASSEMBLY
CAUTION:
switched off before carrying out any work on the
tool.
Type of filter
Normal filter
1
► 1 . Capsule 2. Prefilter 3. Filter
High performance filter
► 1 . Capsule 2. High performance filter
Disposing of dust
CAUTION:
becomes too full, or the suction force weakens.
CAUTION:
inside the cleaner itself. Failure to do so may
cause the filter to be clogged or the motor to be
damaged.
Disposing of dust for normal filter
1.
In order to drop dust sticking on the filter in the
capsule, tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
5 ENGLISH
Always be sure that the tool is
2
1
2
1
Empty the cleaner before it
Be sure to empty out the dust
3