Moving Onto An Obstacle - Nussbaum POWER LIFT HF 3S 5000 Instrucciones De Servicio

9 Operating lever
21 Emergency discharge valve
Preparation
• Loosen and remove the plastic part (T-piece) of
the operating lever (9) at both screws on the side.
• Loosen and remove the stainless steel cover of
the unit.
• After the lift has been set down into the latch then
the lift must first be lifted (using a forklift, electrical
pallet truck or similar) out of the latch so that it
moves freely again. Then tie back the latch using,
e.g. a cable tie.
Emergency discharge:
• Push on the black cap (21) of the valve and at
the same time slowly pull the operating lever (9).
The lowering procedure begins immediately. Low-
ering speed can be varied by the lever position.
• The lowering process must be continuously ob-
served.
• Release the operating lever (9) to stop or if there
is a danger.
• Lower the lift to the lowest position.
88
• Release the latch again (remove cable tie)
• Only operate the lift if it is in seamless condition
from a safety point of view.
9
• If required, firstly inform customer service.
6.2

Moving onto an obstacle

If the lift moves onto an obstacle during lowering,
then it remains in position due to the mechanical re-
sistance. In this case, move the lift upwards by push-
ing the operating lever (9) o "LIFT" (17) on the op-
erating panel until the obstacle can be removed.
21
Afterwards the lift is in a normal work condition and
can continue to be operated as described in the
operating manual.
012
22
OPI-POWER LIFT HF 3S 5000 - HYMAX HF 3S 5000-V1.1-DE-EN-FR-ES-IT