Assembly And Installation; Assembling The Metering Pump - ProMinent Dulco Flex Manual De Instrucciones

ProMinent ®
6

Assembly and installation

CAUTION
• It is not permitted to assemble and install this device with
non-ProMinent parts unless these have been tested and
recommended by ProMinent. May otherwise result in injury
to persons or property for which ProMinent will accept no
liability.
TAKE CARE
• The device is resistant against normal atmospheres in
technical areas.
• The device may not be used outdoors without additional
protection (outer casing, weatherproof cover). The
enclosure rating does not apply if the seals are subjected to
damp and direct sunlight can cause the housing to degrade.
• Installation must comply with relevant national directives.
6.1

Assembling the metering pump

Firstly remove the wall bracket from the device. It is used as a
drilling template
Attach the wall bracket to a wall or panel
Suspend the device in the wall/pipe bracket
lightly onto the bracket
until you hear it engage for a second time
1
3
Fig. 2
3
Assembly and installation
and press down
until it engages. Then push upwards
.
2
23