AGV AX-8 Manual De Instrucciones página 14

1
2
3
CLICK !
4
14
3.2) Quick release buckle retention system
With the quick release buckle retention system, the strap
must be adjusted before being fastened.
Following the indications of the figure below, adjust the
length of the strap, lengthening or shortening the portion of
tape that passes through the metal ring (1) until the helmet fits
snugly when the strap is fastened.
To fasten the helmet, slot the buckle into the retention mech-
anism (2) until it clicks closed (3).
Check that the helmet fits snugly (see the paragraph entitled
"Choosing the right helmet" in the "Safety Warning" book-
let).
5
To remove the helmet, use the
red button (4) to open the re-
tention mechanism and then
open the buckle (5) as shown
in the figure below.