Num'axes IKI VOICE Manual De Instrucciones página 16

The chart below indicates how your collar operates according to the mode you have selected:
Number of beeps
1
2
3
(*): In mode 2 and 3 :
- If your dog continues to bark, after the 4th barking the collar begins again its operating cycle
(beeps for the mode 2 and vibrations for the mode 3).
- If your dog stops barking more than 15 seconds, the collar will also begin again its cycle at the
beginning (beeps for the mode 2 and vibrations for the mode 3).
Recording and listening of vocal messages
ATTENTION: to proceed to the recording or listening of the vocal messages, your collar must be
switched off.
You have the possibility of recording 2 vocal messages of 5 seconds each. We advise you to use short
words and employ a firm tone (without shouting).
Examples of messages: « no! » ; « stop! » ; « silence! »... which you can make follow or precede
by the name of your dog.
To record or listen your messages, proceed in the following way:
- Remove the 2 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Press and hold the button (See Diagram 5 below) a series of beep sounds (from 1 to 4) will be
emitted by the collar indicating the selected mode.
- Release the button when you have reached your desired mode.
- When you have finished listening or recording your vocal messages
- Replace the battery cover taking care to first insert the little pin at the bottom of the battery
cover (See diagram 3).
- Retighten moderately the 2 screws.
Mode
1
2(*) Beep sounds then vocal messages :
2nd barking : vocal message 1
3rd barking : vocal message 2
3(*) Vibrations then vocal messages :
2nd barking : vocal message 1
3rd barking : vocal message 2
Gb - 16
Function
Vibrations + beep sounds
1st barking : beep sounds
1st barking : vibrations