Replacing The Batteries; Replacing The Paper Roll - Sharp XE-A201 Manual De Instrucciones

A201_5 OPERATOR MAINTENANCE
4

Replacing the Batteries

This cash register displays a low battery symbol (
symbol (
When the low battery symbol is displayed, replace the batteries with new ones as soon as possible. The
existing batteries will be dead in about two days.
When the no battery symbol is displayed, replace the batteries immediately. Otherwise, if the AC power cord is
disconnected or a power failure occurs, all the programmed settings will be reset to the default settings and any
data stored in memory will be cleared.
To replace the batteries:
5

Replacing the Paper Roll

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls other than those specified could cause paper jamming, resulting in register
malfunction.
Paper specification
Paper width: 57.5 ± 0.5 mm
• Be sure to set paper roll(s) prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful to set the roll and cut the paper end correctly.
If the top end of the paper roll is fixed with paste or tape, the paper may lose its color development ability in the
pasted or taped area due to the deterioration of the heat-sensitive color development component of the paper
surface. This may result in nothing appearing at this location when printing. Therefore, when setting a new paper
roll in the machine, be sure to cut off approximately one revolution (approx. 25 cm long).
(How to set the paper roll)
Downloaded from: http://www.usersmanualguide.com/
01.11.11 10:24 AM
) when batteries are extremely low or batteries are not installed.
Be sure to observe precautions shown on page 1 when handling batteries.
1.
Make sure that the cash register is plugged in.
2.
Turn the mode switch to the REG position with the power cord connected.
3.
Remove the printer cover.
4.
Open the battery compartment cover and remove the old batteries.
5.
Install three new R6 or LR6 batteries ("AA" size) in the battery compartment.
Be sure the positive and negative poles of each battery are facing in the
proper direction. When they are installed correctly, the "
will disappear.
6.
Close the battery compartment cover.
7.
Replace the printer cover.
Max. outside diameter: 80 mm
To the printer
Correct Incorrect
Page 63
) when the batteries are low, and displays a no battery
(How to cut the paper end)
To the printer
" or "
Quality: Thermal paper
Correct Incorrect
" symbol
63