Replacing The Batteries; Replacing The Paper Roll - Sharp XE-A212 Manual De Instrucciones

A212_5 OPERATOR MAINTENANCE
4

Replacing the Batteries

This cash register displays a low battery warning message "LOW BATTERY" when the batteries are low, and
displays a no battery warning message "NO BATTERY" when batteries are extremely low or batteries are not
installed.
When the low battery message is displayed, replace the batteries with new ones as soon as possible. The
existing batteries will be dead in about two days.
When the no battery message is displayed, replace the batteries immediately. Otherwise, if the AC power cord
is disconnected or a power failure occurs, all the programmed settings will be reset to the default settings and
any data stored in memory will be cleared.
Be sure to observe precautions shown on page 1 when handling batteries.
To replace the batteries:
5

Replacing the Paper Roll

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls other than those specified could cause paper jamming, resulting in register
malfunction.
Paper specification
Paper width: 57.5 ± 0.5 mm
Max. outside diameter: 80 mm
Quality: Thermal paper
• Be sure to set the paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful to set the roll correctly.
(How to set the paper roll)
74
03.7.5 7:53 AM Page 74
1.
Make sure that the cash register is plugged in.
2.
Turn the mode switch to the REG position.
3.
Remove the printer cover.
4.
Open the battery compartment cover next to the paper roll cradle and
remove the old batteries.
5.
Install three new R6 or LR6 batteries ("AA" size) in the battery compartment.
Be sure the positive and negative poles of each battery are facing in the
proper direction. When they are installed correctly, the "LOW BATTERY" or
"NO BATTERY" will disappear.
6.
Close the battery compartment cover.
7.
Replace the printer cover.
To the printer
Correct
To the printer
Incorrect