Tabla de contenido
Publicidad
Paso 2 -
(Page 2 of 3) en este proceso de calibración se seleccionan las unidades
de ingeniería con la que se va a realizar la calibración. Seleccionar las unidades de caudal
(Flowrate Units) y hacer clic en el botón Next (Siguiente) en la parte inferior de la ventana.
Calibration (Page 2 of 3) - General Setup
Flow Rate Units:
It is advisable to File Save the existing calibration before modifying it. If the Flow Rate Units selected on this page do not
match the Flow Rate Units utilized for the existing data points collected on Page 3 of 3, flow measurement errors can occur.
To view measurement units, go to Page 3 of 3 and press Edit. The Calibration Points Editor will show what units
were used during the existing calibration.
1) If no data exists in the editor, selection of Flow Rate Units will not influence measurements.
2) If new calibration points are to be entered on Page 3 of 3, it is advisable to remove the existing calibration
points using the Calibration Points Editor.
File Open...
File Save...
IM-P197-02 MI Issue 1
/
Gallons
Min
Fig. 48 Pantalla Calibration (Page 2 of 3)
<Back
Next>
Cancel
79
Publicidad
Tabla de contenido
