Electrical • Operation - Flotec E3375TLT Manual Del Usuario

Electrical • Operation
Electrical
Hazardous voltage . Can shock, burn, or
kill. When installing, operating, or servicing this pump,
follow the safety instructions listed below.
• DO NOT splice the electrical power cord.
• DO NOT allow the electrical cord plug to
be submerged.
• DO NOT use extension cords. They are a fire
hazard and can reduce voltage sufficiently to
prevent pumping and/or damage motor.
• DO NOT handle or service the pump while it is
connected to the power supply.
• DO NOT remove the grounding prong from
the plug or modify the plug. To protect against
electrical shock, the power cord is a three-wire
conductor and includes a 3-prong grounded plug.
Plug the pump into a 3-wire, grounded, grounding-
type receptacle. Connect the pump according to
the NEC or CEC and local codes.
For automatic operation, plug the pump into an
automatic float switch or duplex controller. The pump
will run continuously when plugged directly into an
electrical outlet.
Connect pump to its own individual branch circuit with
no other outlets or equipment in the circuit. Size fuses or
circuit breakers according to Specifications.
Risk of electrical shock and fire . Can burn,
kill or cause property damage. Be sure that power supply
information (Voltage/ Hertz/Phase) on pump motor
nameplate matches incoming power supply exactly.
Install pump according to all electrical codes that apply.
WARNING
Risk of electrical shock.
Can burn or kill.
Do not lift pump by power
cord.
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
Operation
personal injury, property damage or death. Do not use in
explosive atmospheres. Pump water only with this pump.
NOTICE: Do not allow the pump to run in a dry sump. It
will void the warranty and may damage the pump.
An automatic overload protector in the motor will
protect the motor from burning out due to overheating/
overloading. When the motor cools down, the overload
protector will automatically reset and start the motor.
If the overload trips frequently, check for the cause.
It could be a stuck impeller, wrong/low voltage, or
an electrical failure in the motor. If an electrical
failure in the motor is suspected, have it serviced by a
competent repairman.
The pump is permanently lubricated. No oiling or
greasing is required.
Cord Lift Warning
Risk of fire or explosion . Can cause severe
Risk of electrical shock and fire.
1. Attempting to lift or support the pump by
the power cord can damage cord and cord
connections, expose bare wires, and cause a fire or
electrical shock.
2. Use lifting ring or handle on top of pump for
all lifting or lowering of pump. Disconnect the
power to the pump before doing any work on it or
attempting to remove it from the pit.
3. Lifting or supporting the pump by the power cord
will void the warranty.
5