Work Area Safety; Before Use - Hilti SFL 36-A Manual De Instrucciones

b) Do not expose batteries to high temperatures or fire. This presents
a risk of explosion.
c) Do not disassemble, squash or incinerate batteries and do not
subject them to temperatures over 80°C. A risk of fire, explosion or
injury through contact with caustic substances may otherwise result.
d) Avoid ingress of dampness.Dampness may cause a short circuit
resulting in a risk of burning injury or fire.
e) Do not use batteries other than those approved for use with the
applicable tool or appliance. Use of other batteries or use of the
battery for purposes for which it is not intended presents a risk of fire
and explosion.
f) Observe the special instructions applicable to the transport, storage
and use of Li-ion batteries.
g) Avoid short-circuiting the battery.Before inserting the battery in the
tool or appliance, check that the terminals of the battery and the tool
or appliance are free from foreign objects. Short-circuiting the battery
terminals presents a risk of fire, explosion or contact with caustic
substances.
h) Do not charge or continue to use damaged batteries (e.g. batteries
with cracks, broken parts, bent or pushed-in and/or pulled-out
contacts).
i) If the battery gets too hot to touch, this may indicate that it is faulty.
Place the tool in a location where it can be kept under observation,
well away from flammable materials, and allow it to cool down.
Contact Hilti Service after the battery has been allowed to cool.

5.3 Work area safety

a) Ensure that the workplace is well lit.
b) Take care to ensure that you are not dazzled by the lamp.

6 Before use

6.1 Battery use and care
NOTE
Battery performance drops at low temperatures. Use a battery only when
it has been fully charged. This ensures that maximum battery capacity is
Printed: 08.07.2013 | Doc-Nr: PUB / 5071526 / 000 / 02
en
19