Charging The Battery; Fitting The Battery - Hilti SFL 36-A Manual De Instrucciones

available. Change to the second battery as soon as a drop in performance
is noticed. Recharge the battery immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store the battery where it is
exposed to direct sunlight or sources of heat, e.g. on heaters / radiators or
behind a motor vehicle windscreen. Batteries that have reached the end of
their life must be disposed of safely and correctly to avoid environmental
pollution.
en

6.2 Charging the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting it in the corresponding charger.
Read the operating instructions for the charger for further information about
the charging procedure.
Li-ion batteries are ready for use at any time, even when only partly charged.
Charging progress is indicated by the LED display (see charger operating
instructions).

6.3 Fitting the battery

CAUTION
Check that the appliance is switched off before fitting the battery. Use
only the Hilti batteries approved for use with this appliance.
CAUTION
Before inserting the battery in the tool or appliance, check that the
terminals of the battery and the tool or appliance are free from foreign
objects.
1. Push the battery into the power tool from the rear as far as it will go and
until it is heard to engage with a double click.
2. CAUTION A falling battery may present a risk of injury to yourself or
others.
20
Printed: 08.07.2013 | Doc-Nr: PUB / 5071526 / 000 / 02