Maintaining Your Table Saw; General Maintenance; Lubrication - Bosch 4100XC Instrucciones De Funcionamiento

1600A01Z1U.qxp_4100XC 10/31/19 1:21 PM Page 46

GENERAL MAINTENANCE

plug from power source outlet be fore main-
taining or lubricating your saw.
tempted only by trained repairmen. Contact
the nearest Factory Service Center or Au-
thorized Service Station or other competent
repair service. Use only identical replace-
ment parts, any other may create a hazard.
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
which contain am monia. Avoiding use of
these and other types of cleaning agents will
minimize the possibility of damage.
Do not allow sawdust to accumulate inside
the saw. Frequently use a brush to remove
any dust that may accumulate inside the saw
cabinet and the motor. Clean your cutting
tools (i.e. blades) with a Gum and Pitch Re-
mover.
Periodically clean the guard with a rag or a
brush.
The cord and the tool should be wiped with
a dry clean cloth to prevent deterioration
from oil and grease.
A coat of automobile-type wax applied to the
table will help to keep the surface clean and
allow workpieces to slide more freely.
If the power cord is worn or cut, or damaged
in any way, have it replaced immediately.
Make sure the teeth of the anti-kickback de-
vice are always sharp. To sharpen:
A. Remove anti-kickback device from riving
Fig. 67

Maintaining Your Table Saw

For your own safety, turn
switch "OFF" and remove
All repairs, electrical or
mechanical, should be at-
Certain cleaning agents
and solvents can damage
knife.
B. Rotate one pawl away from the other.
C. Hold pawl over corner of workbench
(Fig. 67).
D. Using a small round file (Smooth Cut)
sharpen the teeth.

LUBRICATION

The gear case has been completely lubricated
at the factory. However, after six months to
one year, depending upon use, it's wise to re-
turn your tool to the nearest Service Center
for the following:
● Brushes replaced.
● Parts cleaned and inspected.
● Relubricated with fresh lubricant.
● Electrical system tested.
● All repairs.
The following parts should be oiled occasion-
ally with SAE No. 20 or No. 30 oil, or WD-40
(Fig. 68):
1. Sliding rails and supports.
2. Table locking cams (Front and Rear).
46
Fig. 68
2
1
2