Adjusting 0 Degree Positive Stop; Adjusting 45 Degree Positive Stop - Bosch 4100XC Instrucciones De Funcionamiento

1600A01Z1U.qxp_4100XC 10/31/19 1:21 PM Page 28
Adjusting 0 and 45 Degree
Positive Stops
plug from power source when making ad-
justments.
Your saw is equipped with positive stops for
fast and ac curate positioning of the saw
blade at 90 and 45 degrees to the table.
1. Turn elevation wheel 2 clockwise and
raise blade
(Fig. 31).
ADjUSTING 0 DEGREE POSITIVE
STOP:
2. Loosen the blade tilt lock handle 1 and
push the elevation wheel to the left as
far as possible and tighten the blade tilt
lock handle (Fig. 31).
3. Place a combination square on the table
with one end of square against the
blade as shown (Fig. 32), and check to
see if the blade is 90 degrees to the
table. If the blade is not 90 degrees to
the table, loosen the blade tilt lock han-
dle, loosen 90 degree adjustment screw
4, loosen 90 degree bevel stop cam 5
and push the elevation wheel until the
blade is 90 degrees to the table.
4. Tighten blade tilt lock handle, rotate the
bevel stop cam until it touches the bevel
stop housing 7, then tighten 90 degree
adjustment screw 4.
5. Loosen adjustment screw 6 and adjust
pointer 3 to indicate 0 degrees on the
bevel scale.
ADjUSTING 45 DEGREE POSITIVE
STOP:
6. Loosen the blade tilt lock handle and
push the elevation wheel to the right as
far as possible and tighten the blade tilt
lock handle.
7. Place a combination square on the table
with one end of square against the blade
as shown (Fig. 33), and check to see if
the blade is 45 degrees to the table. If
the blade is not 45 degrees to the table,
loosen the blade tilt lock handle, loosen
45 degree adjustment screw 8, loosen
45 degree bevel stop cam 9 and push the
28
Adjustments
To prevent personal in-
jury, always dis con nect
to maxi mum height
Fig. 31
4 3 1
5
7 6
elevation wheel until the blade is 45 de-
grees to the table.
8. Tighten blade tilt lock handle, rotate the
45 degree bevel stop cam 9 until it
touches the bevel stop housing 7, then
tighten 45 degree adjustment screw 8.
9 8
2
Fig. 32
Fig. 33