Using The Rip Fence Pointer When Table Is Not Extended; Using The Table Pointer When Table Is Extended - Bosch 4100XC Instrucciones De Funcionamiento

1600A01Z1U.qxp_4100XC 10/31/19 1:21 PM Page 37
narrower, use rip fence on the right side of
the blade ONLY. This will provide more space
between the rip fence and the sawblade for
use of a Push Stick. If the rip fence is
mounted to the left, the sawblade guard may
interfere with proper use of a Push Stick.
Attach auxiliary fence AF to rip fence with
two "C" clamps (Fig. 48).
Feed the workpiece by hand until the end is
approx. 1" (25mm) from the front edge of the
table. Continue to feed using the PUSH
BLOCK 3 on top of auxiliary fence UNTIL THE
CUT IS COM PLETE (Fig. 49).
USING THE RIP FENCE POINTER
WHEN TABLE IS NOT EXTENDED
The rip fence pointer shows the distance
from the blade to rip fence through a conven-
ient viewing and magnifying window.
Fig. 54
6
5
Basic Table Saw Operation
7
15 14
10 11 12 13
Align rip fence pointer 4 with lower portion
of scale 5. The lower scale can be used for
widths up to 14.5 inches [368mm] (Fig. 54).
USING THE TABLE POINTER WHEN
TABLE IS EXTENDED
Move the rip fence to the 14.5" mark and lock
in place. The upper portion of scale 6 is used
for rip cut 14.5 to 30 inches (368 to 762mm).
Align table pointer 7 with upper portion of
scale 6 (Fig. 54).
14
4
37