Bosch 11250VSR Instrucciones De Funcionamiento página 10

Ocultar thumbs Ver también para 11250VSR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2610047982.qxp_11250VSR,VSRD 10/2/17 1:01 PM Page 10
INSTALLING & REMOVING ACCESSORIES
FIG. 6
3-JAW CHUCK
For small bits, open jaws enough to insert the
bit up to the flutes. For large bits, insert the bit
as far as it will go. Center the bit as you close
the jaws by hand. This positions the bit
properly, giving maximum contact between the
chuck jaws and the bit shank (Fig. 6).
To tighten chuck, insert key into each of the
three key holes in succession and tighten
clockwise firmly.
2
The chuck can be released by using one hole only.
Note: The 3-Jaw Chuck is for use only in "Drill
only" mode. The 3-Jaw Chuck is not for use
when drilling with hammering action.
OFFSET AUXILIARY HANDLE
FIG. 7
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚.
To reposition and/or swivel the handle, loosen
the hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 7).
HAND GRIP
Operating Instructions
VARIABLE SPEED CONTROLLED
FIG. 8
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum
REVERSING
nameplate RPM by the pressure you apply to
SWITCH LEVER
the trigger. Apply more pressure to increase
the speed and release pressure to decrease
speed. This accurate speed control enables
VARIABLE SPEED
you to drill without center punching. It also
CONTROLLED
permits you to use as a power screwdriver.
TRIGGER SWITCH
Bits are available for driving screws as well
as running bolts and nuts (Fig. 8).
-10-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

11250vsrd

Tabla de contenido