Fermax DUOX Manual De Instalador página 29

CONSOLE MODE (CM)
This operating mode allows for carrying out programming operations and verifying the
programmed parameters in any device from the DUOX family, that is, telephones, amplifiers
and DUOX relays (when available), and individually.
You have to power the device to verify/program and the DUOX programmer.
It can be done in two ways:
Powering the programmer from the device to be programmed.
This option is useful when we have the telephone to program installed and powered from
the installation itself. (Except EXTRA telephones, that don't have power for the verifier).
The programmer is powered via the telephone connection cable (This can be the telephone's
coiled cable, which is connected between the telephone body and the programmers RJ11
connector, or it can be via the 3 way connectors located on the back of the programmer,
using a flat cable and connecting the 2 wires on the ends to the telephone connector or
directly to the bus)
Locally powering the programmer
This option is useful when we have the device out of the installation or in the workshop
bench.
We will power the programmer via the USB connector, using a USB power supply.
In either case, to complete the programming of a device, simply disconnect it from the power
and press the ON/OFF key for at least 2 seconds.
CONNECTION OFF
NOTES
This operating mode, and specifically the available options, will depend on the device (and
its version) to program, so they may vary slightly with respect to those indicated in these
technical instructions.
As of the date of publication for these technical instructions (January 2014), this mode is
only available for the following models:
- Loft Extra
- Loft Basic Plus
The availability for new devices will be reported once available.
If the equipment is not used for more than a minute, it will
automatically turn off, having to be disconnected and reconnected
to the power for it to continue working, after which you have to
press the ON/OFF key again for 2 seconds.