Fermax DUOX Manual De Instalador página 39

DETECTING RELAYS (IM)
This function allows you to verify the existence of one or various relays in the installation,
programmed within a range of indicated relay numbers and as part of the same block,
including the relays configured as F1 and F2.
No relays have
been detected
TEST RESULT:
NO RELAYS
Exit this function and return to the DEVICE DETECTION menu
ESC
1. DETECTOR
RELE
OK
1 2 3
1. DETECTOR
4 5 6
BLOCK: 00
7 8 9
OK
1 2 3
1. DETECTOR
4 5 6
START: 0000
7 8 9
OK
1 2 3
1. DETECTOR
4 5 6
END: 0000
7 8 9
OK
Start scanning, viewing it as it goes.
RELAYS The group with two digits to the left indicates the block
00 000
number and the three right ones is the relay number being
verified.
After having completed the scan, you can present one of these 3
results:
Only some relays
have been detected
All relays
have been
detected
TEST RESULT:
ALL RELAYS
We start from the DETECTING RELAYS option from the
DEVICE DETECTION menu
Enter the Block number that the relays to verify belong
to.
Values admitted: 00 to 09
0
ESC
Enter the number of the first relay in the range.
0
ESC
Enter the address of the last relay in the range.
(this number must be greater than the first number
in the range)
0
ESC
TEST RESULT: ?
DETECTED
TEST RESULT: ?
NO DETECTED
OK
RELAY OK
0003
The relays detected are
displayed
OK
RELAY NO OK
0020
The relays NOT detected
are displayed