Fermax DUOX Manual De Instalador página 36

INSTALLATION MODE (IM)
From the MAIN MENU, you can access all of the DUOX programmer's functions with
regards to the detection of already installed devices in a specific installation, analyse the
quality of digital frames in a specific point of the installation, verify the different commands
that are transmitted by any device on the installation, and the transmission to a PC of
these commands, transmitted for a determined period of time to be registered and then
sent to the factory if required in-depth analysis for some technical problem in the installation.
The available functions are:
- Component detection (telephones, relays, panels or guard units).
- Analysis of commands transmitted by the different devices.
- Measuring the quality (level) of the digital frames.
- Monitoring and registering a PC of the transmitted commands.
This is accessed via the main MENU as indicated in the following diagram and once the
programmer is connected to a BUS within the installation via the 3 way connector (see
the DESCRIPTION section).
Press ON/OFF for 2 seconds to turn the programmer off.
ON
OFF
ON
OFF
A welcome message appears indicating the DUOX´s
DUOX ANALYZER
programmer software version.
V.1.0
OK
1. DETECTOR
2. ANALYZER
3. METER
4. SNIFFER PC
OK Access the DEVICE DETECTION menu
OK
Access the COMMAND ANALYSIS menu
Access the MEASURE FRAME LEVEL menu
OK
Access the REGISTERING FRAMES ON A PC
OK
menu