Electrical Connection - Euronda EUROSONIC 4D Manual De Instrucciones

EUROSONIC 4D
®
In the case where the electric power cannot be disconnected, turn the mains
switch to the "off" position, and if it is out of sight or reach of the mainte-
nance operator, place a "work in progress" sign on it.
If the machine doesn't WORK properly refer to the selection in the manual
WARNING
"Solution to Problems" for the possible cause. If you need subsequent informa-
tion or the machine has to be repaired contact the specialised personnel of the
supplier or the technical office of Euronda S.p.A.
DO NOT LET THE LIQUID DROP BELOW THE MINIMUM LEVEL IN THE BASIN.
ENSURE THAT THE PLANT IS PROVIDED WITH EARTHING IN CONFORMITY WITH THE CUR-
RENT STANDARDS FOR THE COUNTRY WHERE IT IS INSTALLED.
DO NOT REMOVE THE LABEL STUCK TO THE MACHINE
WARNING
ENSURE THAT THE CLEANING MACHINE IS USED WITH THE CORRECT VOLTAGE
NEVER USE THE CLEANING MACHINE WITH SOLUTIONS AT TEMPERATURES HIGHER THAN 70° C
USE EXCLUSIVELY THE ORIGINAL REFILLS
- The apparatus conforms to the electrical safety requirements set out by the Standards
Institute, and is provided with a bipolar plug which ensures complete earthing.
- As a fundamental safety requirement, make sure that the electric installation is efficiently
earthed and the capacity of the installation and electric current sockets is adequate for the
apparatus power shown on the rating plate. Have qualified personnel carry out the above
checks.
FAILURE TO FOLLOW THE ABOVE INSTRUCTIONS RELIEVES EURONDA S.P.A.
Check that the electrical current indicated on the tag on the rear of the machine, corresponds
to the voltage of the place of installation.
The machine must be connected to an electrical system with adequate voltage which corre-
sponds to all standards laws of the country of installation.
ATTENTION: Don't fold or twist the electrical cable and don't lay any objects on it.
WARNING
WARNING
OF ANY LIABILITY UNDER THE WARRANTY.

ELECTRICAL CONNECTION

7