The EUROSONIC
®
ultrasound basin has been tested and inspected in the factory.
Remove the packing and install the apparatus observing the following instructions:
1. Position the ultrasound basin on a flat surface, leaving a clear area of at least 50-80 mm
around it.
2. Do not install the machine close to a sink or similar to avoid contact with water and possi-
ble electrical short circuits.
3. Keep the machine far from heat sources.
4. Install the machine in a ventilated area.
5. Ensure that the electrical cable is not folded up and freely reaches the electrical socket.
6. The device must be positioned in such a way that the plug is accessible.
7. Insert the plug: the machine is ready for use.
ATTENTION
ATTENTION
ment, when choosing the place where the ultrasound apparatus is to be installed, due
consideration must be given to the effects caused by evaporation and progressive
WARNING
vapourisation of the detergent liquid, especially if the machine is used without a lid.
If volatile or aggressive solutions are brought in contact with the machine fumes and
vapours can spread throughout the environment and create problems to the surround-
ing equipment and fixtures.
SAFETY
Before using your EUROSONIC
warnings. Failure to observe them can cause accidents or damage the apparatus.
DO NOT USE FLAMMABLE LIQUIDS IN THE BASIN
DO NOT USE SOLVENTS IN THE CLEANING MACHINE
DO NOT USE THE APPARATUS NEAR GASES OR EXPLOSIVE VAPOURS
KEEP THE AREA AROUND THE CLEANING MACHINE CLEAN AND DRY
Eliminate any spilt liquid. Water and high voltage can produce an electrical discharge.
WARNING
DO NOT PLACE YOUR HANDS IN THE BASIN WHEN THE APPARATUS IS WORKING
NEVER DISASSEMBLE THE EUROSONIC
ITS HIGH INTERNAL VOLTAGE IS DANGEROUS
6
PART 2
INSTALLATION
: Do not use the apparatus to disinfect, clean or rinse contact lenses.
: In order to safeguard the apparatus and the surrounding environ-
ultrasound cleaning machine, carefully read these safety
®
4D CLEANING MACHINE
®
EUROSONIC 4D
®