16
OPERATION
16.1
Hand bandsaw set-up procedure
Machine must be voltage-free and separated from the main.
HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
1. Check the belt tension:
The belt tension is controlled by hand and if it
is possible to push it more than 10cm, the belt
should be tightened.
2. Check blade tracking
3. Check blade guide adjustment
CAUTION
Slide the blade guide over the blade
so that only the required cut distance
remains free.
4. Check saw blade tension:
Proper blade tension is achieved if the blade
defects no more than 3-6 mm when it is firmly
moved by hand at the center location of the
blade.
5. Check level of lubrication tank and refill if
necessary.
NOTICE
Use only water with a light detergent
(soapy liquor; Washing up) as a coolant.
OPERATION
27
BBS 350