Operation; Operation; Cleaning, Maintenance, Storage, Disposal; Cleaning - HOLZMANN MASCHINEN BBS350 Instrucciones De Servicio

16.2

Operation

17

OPERATION

18

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

18.1 Cleaning

The use of solvents, aggressive chemicals or abrasives can lead to damage to
paintwork and other property on the machine!
Free the machine from dust and other deposits after each use. Only use water and, if necessary,
a mild detergent for cleaning! The use of compressed air or high-pressure cleaners is not
recommended. The latter can reduce the operational suitability of the machine or shorten its
service life, because water (moisture) could get inside the machine when it is used.

18.2 Maintenance

Danger due to electrical voltage! Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against accidentally re-
activation!
The machine does not require extensive maintenance
Malfunctions or defects that are likely to impair your safety must be rectified immediately!
• Check that the safety devices are in good condition before each operation.
• Check the connections at least once a week for a tight fit.
• Check the correct and readable status of the Machine's warning and safety labels on a
basis
18.2.1

Adjusting belt tension

HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
 Place a log onto the track and secure it with the
log assembled supports.
 Press the ON button.
 Wait until saw blade reaches maximum speed.
 Turn on the lubrication.
 Set desired cutting height.
 Slide saw head slowly over the track.
 Turn off the machine after completing operation
with the OFF-button.
NOTICE
and only a few parts require maintenance.
Loosen the 4 nuts on the motor.
The motor can be moved with the two bolts,
depending on the direction, more or less
pulley tension can be applied. After correct
belt tension is achieved, the 4 nuts must be
tightened again.
OPERATION
regular
28
BBS 350