Adjusting Blade Tracking - HOLZMANN MASCHINEN BBS350 Instrucciones De Servicio

18.2.2

Adjusting blade tracking

Right side
Left side
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
www.holzmann-maschinen.at
The blade should have the same distance
between teeth to band wheel on both sides. If
not, the following settings must be achieved.
1. Remove blade guide to ensure no influence on
tracking while adjusting.
2. Take some tension off of the blade.
3. Adjusting the Right side:
Loosen the screw. With the adjustment screw,
the angle of the wheel can now be changed. To
move the blade on the wheel backwards, this
screw must be rotated clockwise. Alternatively,
turning the anti-clockwise bolt would force the
blade to run more forwards on the wheel.
4. Adjusting the Left Side
Loosen the vertical screws by half a turn, this will
take the clamping force off of the bandwheel
shaft and allow it to move freely in the following
steps.
Moving the blade forward:
Fix the horizontal screw (with a tool) and loosen
the outer horizontal nut by a 1/2 turn. Then
rotate the horizontal screw clockwise around a
1/2 turn.
Moving the blade backwards:
Fix the horizontal screw (with a tool) and loosen
the outer horizontal nut by a 1/2 turn. Then turn
the horizontal inner nut clockwise around a 1/2
turn.
Then tighten the vertical screws again.
Re-tension the blade and control blade tracking.
Repeat the above steps if further compensation
is required
29
BBS 350