Disposal - HOLZMANN MASCHINEN BBS350 Instrucciones De Servicio

Aserradero de cinta
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

18.4 Disposal

Observe national waste disposal regulations. Do not dispose of the machine,
machine components or operating materials in residual waste. If necessary,
contact your local authorities for information on available disposal options.
If you buy a new machine or an equivalent machine from your retailer, he is
obliged in certain countries to dispose of your old machine properly.
19
TROUBLESHOOTING
Danger due to electrical voltage! Manipulating the machine when connected to
the power source can cause serious injury or death. Always disconnect the machine
from the power supply before troubleshooting and secure it against unintentional
restarting! Repair work may only be carried out by qualified personnel!
Problem
Producing wavy cuts
Last board is tapered or
narrow in the middle.
Blade comes off of band
wheels
Blades are breaking.
Blade is slowing down or
stopping when milling
Mill is not cutting/cutting
very
slowly.
Mill is vibrating excessively.
HOLZMANN MASCHINEN GmbH
Possible cause
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Sap build up on blade.
5. Dull blade.
6. Pushing mill too quickly.
Tracks are not levelled.
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Belts are worn.
5. Dull blade.
6. Pushing mill too quickly.
1. Too many blade sharpening's.
2. Inadequate blade tension.
3. Improper blade guide set up.
4. Improper blade tracking.
5. Pushing mill too quickly.
1. Inadequate blade tension.
2. Improper drive belt tension.
3. Pushing mill too quickly.
1. Dull blade.
2. Blade-teeth are backwards.
1. Log is not clamped securely.
2. Belts are deformed.
3. Bandwheel bearing issue.
4. Pushing mill too quickly.
5. Loose bolts.
www.holzmann-maschinen.at
WARNING
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new blade and ensure to run
always with blade lubrication.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
Level the tracks
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
1. Install new blade
2. Adjust blade tension
3. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Slow feed rate down and push head
slower through log.
1. Tighten blade
2. Adjust V-Belt tension
3. Slow feed rate down and push head
slower through log
1. Install new blade
2. Assemble blade correct
1. Ensure log is clamped firmly resting on log
bunks and against log supports.
2. Install new Belts
3. Install new band wheel bearings
4. Slow feed rate down when milling.
5. Check all bolts to ensure they are tight.
TROUBLESHOOTING
Remediation
BBS 350
32

Publicidad

Tabla de contenido
loading

Tabla de contenido