Troubleshooting Ro Ag8000; Care And Maintenance; Accessories; Customer Service - Rothenberger RO AG8000 Instrucciones De Uso

The battery pack was not pushed correctly onto the sliding seat (2).
4

Troubleshooting RO AG8000

Symptom
5

Care and Maintenance

RO AG8000:
Cleaning:
Clean the dust filter regularly: remove and clean with a jet of compressed air.
RO BC14/36 Charger:
Repairs to the charger must only be carried out by qualified electricians.
If the mains connection cable of this tool is damaged, in order to prevent endangering personnel
and property it must be replaced by the manufacturer, or the Customer Service of the manufac-
turer, or a similarly qualified person.
6

Accessories

Accessory Name
INOX PROFI Plus Cutting disc 125x1.0, box
SAFE CUT Cutting disc 125x2/1, box
2 IN 1 Cutting and grinding disk 125x2,5, box
7

Customer service

The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using our service-after-
sales hotline:
+ 49 (0) 61 95 / 800 – 8200
Phone:
Email: service@rothenberger.com
www.rothenberger.com
8

Disposal

Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmental friendly dispos-
al of the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal
authority.
Old batteries can be taken to your specialist dealer who will dispose of them in conformity with
environmental regulations.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European
Directive 2012/19/EC on waste electrical and electronic equipment and its implementa-
tion as national law, electric tools that are no longer serviceable must be collected
separately and utilised for environmentally compatible recycling.
Possible Reason
The electronic signal display (7)
lights up and the load speed
decreases. The temperature is
too high!
The electronic signal display (7)
flashes and the machine does
not start. The restart protection
is active.
www.rothenberger.com
ENGLISH
Solution
Run the machine in idling until the
electronics signal indicator switches
off.
The machine will not start if the battery
pack is inserted while the machine is
on. Switch the machine off and on
again.
ROTHENBERGER Part Number
071534D
071552D
071554D
+ 49 (0) 61 95 / 800 – 7491
Fax:
29