LEFT ( CLUTCH SIDE )
CLOSE
OPEN
OPEN
INTERMEDIATE
8
RIGHT ( THROTTLE SIDE )
CLOSE
CLOSE
OPEN
INTERMEDIATE
English
TO OPERATE TOP VENTS
Simply push/slide the switch/lever on each duct to open/close the ducts
as illustrated.
WARNING: Never attempt to adjust ventilation ducts when in motion
riding your motorcycle.
TO OPERATE AIRFLOW SPOILER
TX-4 / XD4
To deploy the spoiler in the down position, simply pull it down by grasping
the center of its chin curtain.
To retract, the spoiler, simply push it up with the heel of your hand.
TO REMOVE/REPLACE FACE SHIELD/PEAK
TX-4 / XD4
To remove shield/peak, remove the two screws from each side of the peak
with flat blade screwdriver or coin. Remove the pressure plate from each
side of the peak. The shield/peak can now be removed.
The black spring clip on each side may be removed for cleaning but please
note that they can only be reinstalled properly in one direction. Do not
remove the base plates from the helmet.