Publicidad
4
English
TO OPEN/CLOSE SHIELD
TX-4 / XD4
Pull the shield latch tab on lower left side of the shield outward to release
latch system and then raise the shield. To close the shield, push down the
shield until the shield latch tab fully latches into place.
Apply one or two drops of supplied silicone lubricant around the edge trim
and on other moving parts and wipe off with soft tissue paper to maintain
proper operation.
WARNING: If your shield becomes too scratched or uncleanable,
replace it with a new one. Impaired visibility causes accidents. Use a
solution of mild soap or detergent and lukewarm water to clean your
shield. Rinse well with clean water, and wipe off with a soft cloth.
Never use petrol, thinner, benzene or any other solvents. There are
many "aggressive" cleaners on the market, including some supposed
to be specifically for use on shield. Arai strongly recommends that you
do not use any such products to clean your shield as some of their
ingredients may have damaging effects on the shield and other plastic
parts installed on your helmet. Do not apply stickers or adhesive tape
to the shield, as this will weaken the hard coating. If tinted, the shield
is for daylight use only.
TO OPERATE BROWVENTS
TX-4 / XD4
The Browvents are operated from fully closed through intermediate, to
fully open positions by simply pulling the vent control down to open,
pushing up to close.
Publicidad
Capítulos
