Publicidad
①
③
④
16
English
②
To replace fabric covering, ensure it is turned right side out, and stretch the
covering over pad ①, and adjust the covering to lie smoothly ②. Then push
the rectangular collar through the pad assembly and adjust into final position,
making sure it is not twisted ③. If tab that says EMERGENCY TAB is drawn out,
draw back the strap of the tab until it stops at the guide ④. Fold flat and cover
the strap of the tab with the fabric covering as shown ⑤.
⑤
WARNING:
outside the guide on the cheekpad, as the strap loop may be caught by
projecting objects when riding.
To replace a cheekpad in helmet, slip pad onto strap.
Place the front tab toward the front of the helmet and push the rear part of
pad until the pad is fully home.
Pull the chinstrap completely through the cheek pad to ensure there is no play
in the chin strap and it is not trapped behind the cheek pad.
ABOUT EMERGENCY RELEASE SYSTEM : The EMERGENCY RELEASE SYSTEM is
to smoothly remove cheekpads that may be a hindrance when rescuers attempt to
remove helmet from an injured helmet wearer. With the label that says EMERGENCY
TAB located between the shell and the cheekpad at each side, rescuers can
recognize that the helmet is equipped with the EMERGENCY RELEASE SYSTEM and
the cheekpads can be removed by pulling the tab downward.
Do not allow more than the tab of the strap to be exposed
Publicidad
Capítulos
