Denon AVR-2803 Instrucciones De Operación página 12

n_ _i_! , swtchtotheDe y me [O'"T'm'
Select (darken) the desired units, "Meters" or "Feet" Sat The Distance TO
Each Speakers
Do YOU Prefer
In Metere? / In Feet?
4:_ Feet
• Use this setting to adjust so that the playback level between the different channels is equal
• From the listening position, listen to the test tones produced from the speakers to adiust the level
• The level can also be adiusted directly from the remote control unit (For details, see page 27 )
£xample When ¸¸Meters ¸¸ _Sselected
,once or Fee ss ec e nStep3 0..,T... ]o..,T.,.
the Delay 1line screen appears automatically Default [_<
,,0m,
_Front L 4&Bm_
Front R &6m
Center &6m
.,,,r 3
5 _<_4_ Select the speaker tO be set _
Set the distance between
the center speaker and
listening position
The distance changes in
units of 01 meters (1 foot)
each time the button is
At the System Setup Menu select "Channel Level" System Setup Menu
Speaker Conflluretlen
Delay Time
_Chennel Level
D11JteJ In
Aeellnment
Video In Assignment
OoIby Diiltel Setup
one2 Control
Switch to the Channel Level screen
J Channel Level
_Teet Tone _4:_
Test Tone Start [_
Level Clearing4
Select "Test Tone"
pressed Select the value
closest to the measured
distance
Delay Time ]
Oefault _<
_ i font L &6m
Front R 3*Q[&
Im_fl_ &6m
E×ample When ge dst_r_ce s set _o
3 6 _t fur the center s_eaker
If "Yes" is selected for "Default", the settings are
automatically reset to the default values
Please note that the difference of distance for every speaker
should be 60 m (20 ft) or less If you set an invalid distance,
a CAUTION notice, such as screen right will appean In this
case, please relocate the blinking speaker(s) so that its
distance is no larger than the value shown in highlighted line
5
Front L &am
_ Enter the setting
The System Setup Menu reappears
The AVR-2803 automatically sets the optimum surround delay time for the listening room
NOTES:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values
(see pages 9, 10)
Select the mode [" Channel Level
Select "Auto" or "Manual" l[u'Te=t Tone _'_
• Auto:
Adjust the level while listening to the test tones Teat Tone Start [_
produced automatically from the different speakers Level Clear [_4
• Manual:
Select the speaker from which you want to produce the
test tone to adjust the level
£xampe:When _he Autu mode is selected
Select "Test Tone Start"
Select "Yes"
j Channel Level
Test Tone _e:_
B_raat Tone Start [_4
Level ¢lear[_
12