Configuring Density Determination; Starting And Initialising The Density Program - KERN AR-A01/PR-A02 Manual De Instrucciones

2.3

Configuring density determination

• SETUP
APPLI-
CATION
DENSITY MODE
MODE
MODE
MODE
INDEX
REFERENCE
TIME BASE
REF. DENSITY
TEMPERATUR
E
2.4

Starting and initialising the density program

To go to density program briefly press «
If in "LIQUID MODE" this takes you directly to Density Determination. In all other
modes the following message appears:
+ 0,998205
OK KAL T-H
Occupancy of function keys:
Key Functions
Import density of measured liquid ==> Continue with relevant density
«OK»
determination.
Determine density of measured liquid.
«KAL»
(See chapter 2.5. Density of liquid "liquid mode")
« T-H 0 20.0C» Set reference density of water (currently set at: 20.0°C)
2
Set reference density of water (currently not defined)
« T-H 0 ---C»
2
14
FIRMLY ON
FIRMLY IN AIR Solid
FIRM POROUS Porous solids
g/cc Current density of measured liquid
0 20,0C Functions
2
Solid and vessel on weighing tray
FLOOR
LIQUID Liquids
ON/OFF Index calculation ON/OFF
8.000 Reference density for INDEX calculation in
g/cc (applied only if REFERENCE <>
0,000)
2,0 Time base for repetition in seconds
(applied only if TIME BASE <> 0.0)
0,998205 Density of liquid used for measuring
(default setting water at 20 °C)
20 C Temperature of water used for measuring
in °C (REF. DENSITY is calculated
accordingly)
».
AR_A01-PR_A02-BA-defsi-0620