What To Do If - AEG SWD81800G1 Manual De Instrucciones

14 www.aeg.com

WHAT TO DO IF...

WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual.
Problem
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the ap-
pliance.
Water flows into the
appliance.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.