Connecting Charger To Power Supply; Charging The Battery - Stihl MSA 160 C Manual De Instrucciones

guard, e.g. during a felling cut. The chain
brake will operate only if it has been
properly maintained and the hand guard
has not been modified in any way.
Check operation of chain brake
Before starting work:
– Disengage the chain brake
– Switch on the chain saw
– Push hand guard in direction of bar
nose. The chain brake is working
properly if the chain comes to a
standstill within a few fractions of a
second
The hand guard must be free from dirt
and move freely.
Chain brake maintenance
The chain brake is subject to normal
wear. It is necessary to have it serviced
and maintained regularly by trained
personnel, such as your STIHL servicing
dealer, at the following intervals:
Full-time usage:
Part-time usage:
Occasional usage:
MSA 160 C
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
N Insert the mains plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
every 3
this process the light emitting diode (1)
months
on the charger lights up green for about
every 6
1 second, then red and goes off again.
months
every 12
months
2
1
1

Charging the Battery

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 41°F (5°C) and 104°F (40°C).
N Push the battery (1) into the
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
English
2
29