Sunrise Medical Jay TC Manual Del Usuario página 10

E NG L IS H
D. RETRO KIT
1. An existing J3 Back can be upgraded to an TC Back
using the Retro Kit. The Retro Kit consists of Back
shell, foam base with TC unit, TC cover, Battery,
Switch Box and switch box mounting kit.
2. To install new TC Back components, take notes or
pictures of your current backrest set up, including
depth and angle adjustments. Remove the hardware
from your current J3 Back, and reinstall in the same
position on the TC shell. One way to help facilitate
proper transfer of hardware is to remove and replace
one side at a time, using the remaining side as a
guide. It is not required to remove any mounting
hardware from the wheelchair.
3. Refer to the user guide that was supplied with
your original backrest to make final adjustments, if
necessary.
4. Follow the directions in Section C to charge and install
your battery.
E. OPERATION
1. Once your switch Box is properly mounted to your
wheelchair, simply plug the connector at the end
of the switch box cable into the connector coming
out of the battery box. The TC back unit is now fully
functional.
2. Push the switch forward to turn on the heat. The LED
in front of the switch will illuminate RED, indicating the
heat is on.
3. Pull the switch back to turn on the ventilation fans.
The LED behind the switch will illuminate BLUE,
indicating the fans are operating.
JAY TC Back MK-129576
I NS TA L L ATI ON / OPE RATION / MA INTEN AN C E
F. EASY CLEANING
1. Back cover
a. Unplug the switch box from the backrest unit.
b. Detach the backrest from the wheelchair.
c. Remove the battery pack from the cover by detaching
the Velcro®.
d. Remove the cover from back shell by detaching the
Velcro®.
e. Unzip the zipper on the bottom of the cover.
f. Remove the foam and TC unit, then turn the cover inside
out.
g. Zip the cover closed to avoid snagging.
h. Machine wash in warm water (50 Deg C).
i. Drip and tumble dry in on Low Heat.
2. TC Unit
a. The TC Unit should be wiped clean with damp cloth on a
regular basis to prevent buildup of dirt and grime.
b. The TC unit should not be removed from the backrest
foam as it is permanently attached.
c. Ensure that the TC Unit is free from damage or
obstructions before refitting the cover.
NOTE: Do not dry clean covers or use industrial washers
or dryers to clean covers. Do not steam autoclave. Do not
bleach. Laundry care symbol definitions are shown.
10
LAUNDRY CARE SYMBOLS
Machine wash (70° C)
Only non-chlorine bleach,
when needed
Drip dry
Do not iron
No chemical cleaning
EU = Rev.2.0