Chap. 2 Limitations; Chap. 3 Technical Data - Flotec COMPAC 150 Manual De Uso Y Manutención

For safety reasons, the pump must always be connected to a safety circuit breaker (FI) with a rated leakage current of
≤ 30 mA, in accordance with standards DIN VDE 0100-702 and 0100-738. Contact a specialised electrician.
Regulation OVE B/EN 60555 Part 1-3 establishes that pumps for swimming pools and ponds with fixed connections
installed in Austria must be powered with an insulated OVE transformer at a secondary rated voltage below 230V.
In Switzerland, all electrically-powered equipment for outdoor use must be connected to an automatic safety switch.
Make sure people do not come into contact with water when the pump is connected to the mains.
Verify that the pump is installed on a flat and solid surface. Never place the pump directly on a stone or sand surface.
Always make sure that the pump is placed in a stable and vertical position.
Verify that the pump never runs without liquids. It can cause serious damages.
Always use a rope and fix it to the handle to immerse the pump in water.
Protect the plug and the power cable from heat, oil or sharp edges.
Make sure the machine is disconnected from electric power supply, before performing maintenance operation.
This appliance can be used by children aged 8 years or over and by persons with limited physical,
sensory or intellectual capabilities, or with limited experience and knowledge, provided that they are
DANGER
supervised or have been instructed in the safe use of the appliance and are aware of the dangers
involved. Children must not be allowed to play with the appliance. Cleaning and user maintenance
must not be carried out by children unless they are supervised
WARNING

Chap. 2 Limitations

The pump cannot be used for sea water and inflammable, corrosive, explosive or dangerous liquids.
Verify that the pump never runs without liquids.
The pump can be used with clean and non aggressive fluids or with fluids containing suspended
particles with a maximum diameter of 5 mm.
Sand or other abrasive substances in the pumped fluid will cause the pump to deteriorate and will
affect its performances.
FLOTEC ComPac electropumps are designed for private use in residential environments and are therefore suited to
drain rain water, infiltrated water, to pump water out of flooded areas, and to transfer clean or moderately dirty fluids.
The pump can be completely or partially submersed.

Chap. 3 Technical data

Mains voltage / Frequency
Absorbed power
Type of protection / Insulation class
Delivery fitting
Maximum flow rate
Maximum head
Maximum depth of immersion
Power cable
Weight
(without power cord)
Maximum dimension of pumped solid particles
Maximum temperature of the pumped fluid
Maximum number of starts per hour
Minimum priming level (A)*
Minimum suction level (B)*
Start level (C)*
(automatic mode)
Stop level (D)*
(automatic mode)
Sound pressure level (Lpa) equal to or less than 70 dB(A)
Sound emission values obtained in conformity with the EN 12639 standard
(*) These data refer to Fig. 1, Pag. 91. Measurements are expressed in millimetres.
The maximum flow rates given are reached if the pump is used without the check valve supplied.
Pollution of the liquid could occur due to the leakage of lubricants
(in continuous mode)
(uniformly distributed)
(manual mode)
TRANSLATION FROM ORIGINAL INSTRUCTIONS
ComPac 150
230 V ~ 50 Hz
300 Watt
IP 68 / F
41,90 mm (1"1/4 M)
8.500 l/h
7 m
7 m
10 m H07 RN8-F
(10 m H05 RNF_N1080031)
3,6 Kg
5 mm
40° C
30
15 mm
2 mm
140 mm
30 mm
2
GB
GB
ComPac 200
230 V ~ 50 Hz
650 Watt
IP 68 / F
41,90 mm (1"1/4 M)
11.500 l/h
10 m
7 m
10 m H07 RN8-F
4,8 Kg
5 mm
40° C
30
15 mm
2 mm
140 mm
30 mm
7